Epix10+ Strobe Auxiliary Light | White

Swedish in-house developed design Epix10+ Strobe in elegant ivory white from Ledson is an innovative series of driving lights that elevates your vehicle to the next level, also equipped with 5 different flash patterns, one of which is R65-approved. With a Swedish design language (developed in-house by Ledson) and outstanding performance, these driving lights give your vehicle a truly unique and exclusive appearance that is guaranteed to draw attention! Experience exceptional brightness and design in perfect balance. Flash patterns Single flash (ECE R65-approved), double flash, triple flash, quadruple flash, continuous hyper flash. Synchronisable and with alternating flash patterns Epix10+ Strobe units can be synchronised with each other, meaning all driving lights use the same flash pattern and flash simultaneously. It is also possible to use alternating flash mode, which means your driving lights can be divided into two groups that flash opposite each other (e.g. right / left or upper / lower). All flash patterns can be used in alternating mode, giving you 10 different flash options with this function. You can synchronise and use alternating flash mode with an unlimited number of driving lights — there are no limitations. Dynamic position light Epix10+ Strobe activates the position light dynamically with an impressive sweeping motion that moves the light smoothly from one side of the lamp to the other before it fully illuminates. This effect gives you and your vehicle a distinct and unique appearance. Pulse-controlled Powerboost – It doesn’t get any easier Epix10+ Strobe comes equipped with Ledson Powerboost – an extra power mode for those moments when you need (or simply want) maximum light output. A simple action with the high beam stalk activates this impressive brightness, allowing you to easily adjust the light output to your needs. With the new generation of Powerboost from Ledson, you switch mode with the headlight flasher (tapping the high beam lever) through a few simple steps shown here. NOTE: your driving light is delivered in E-approved mode; follow the instructions to activate Powerboost mode. Features and technical data: Ivory white design that matches, among others, Scania’s white colour tone Strobe light with five different flash patterns (one R65-approved) Selectable position light with dynamic activation (amber or xenon white, connect the colour you prefer) Range in E-approved mode: 359 m (1 lux) Range in Powerboost mode: 647 m (1 lux) Driving beam light pattern (enhances the vehicle’s original high beam pattern) E-approved ECE R112 (Ref. 30), R7 (white position light) EMC-protected ECE R10 (does not interfere with radio) E-approved mode: 2,640 lumens (theoretical), 2,112 lumens (actual) Powerboost mode: 11,500 lumens (theoretical), 8,200 lumens (actual) Neutral white light (5000K) ETM (Electronic Thermal Management) – adjusts LED output depending on temperature for optimal lifespan Side-reflective optical system Pressure equalisation membrane Aluminium heat sink Adjustable stainless steel bracket Polycarbonate lens 36-month warranty Technical data: 150W (10 x 15W Cree LED), strobe light 20W (4 x 5W LED) IP69K (water/dustproof) Cable with 6-pin DT-connector Voltage 9–36 V Power draw in E-approved mode: 2.2A @ 12V and 1.1A @ 24V (high beam only, without position light) Power draw in high beam Powerboost mode: 10.6A @ 12V and 4.8A @ 24V (high beam only, without position light) Dimensions & weight: Width: 247 mm Height: 145 mm (incl. bracket) Depth: 86 mm Weight: 1.6 kg Included: One Ledson Epix10+ Strobe Ivory White LED driving light 10" Bracket, bolts, and screws for mounting the driving light with one or two mounting points DT-connector (6-pin), complement with Ledson Connect Installation manual (see PDF here) Wiring instructions for cables (full installation manual included): Red: Driving light (+) Black: Driving light / Position light (– ground) White: Position light (+) white light Yellow: Position light (+) amber light Green: Strobe light (+) Blue: Synchronisation & pattern (+) Brown: Alternating mode (+) NOTE: The DT connector must not be cut, as this increases the risk of moisture damage and voids the warranty. Technical information: E-marking ECE R10, ECE R112, ECE R65, R7 Height (mm) 145 (incl. bracket) Width (mm) 247.000000 Synchronisable strobe light Array Flash patterns 5 pcs Powerboost Yes Lumen (theoretical) Powerboost: 11500 Lumen (actual) Powerboost: 8200 Manufacturer Ledson Size (inch) 10 inch Color temperature 5000 IP rating IP69K 1 lux at distance 359 m, Powerboost: 647 m Voltage 9–36 V Power consumption 12V 2.2A / 10.6A Power consumption 24V 1.1A / 4.8A Width (mm) 247 Depth 86 Beam pattern Driving beam Function (position) Strobe light, Driving light, Position light