Epix10+ Auxiliary Light | White

Swedish in-house developed design Epix10+ in elegant white (ivory white) from Ledson is an innovative series of driving lights that elevates your vehicle to the next level. With a Swedish design language (developed in-house by Ledson) and outstanding performance, these driving lights give your vehicle a truly unique and exclusive appearance that is guaranteed to attract attention! Experience exceptional brightness and design in perfect balance. Dynamic position light Epix10+ activates the position light dynamically with an impressive sweeping motion that moves the light smoothly from one side of the lamp to the other before fully illuminating. This effect gives both you and your vehicle a distinct and unique character. Pulse-controlled Powerboost – It doesn’t get any easier Epix10 comes equipped with Ledson Powerboost – an extra power mode for the times when you need (or simply want) maximum brightness. A simple movement with the high-beam stalk activates this impressive brightness, allowing you to easily adjust the amount of light as needed. With the new generation of Powerboost from Ledson, you switch mode very easily using the headlight flasher (tapping the high-beam stalk) through a few simple steps shown here. NOTE: Your driving light is delivered in E-approved mode; follow the instructions to activate Powerboost mode. Features and technical data: Ivory white design that matches, among others, Scania’s white colour tone Selectable position light with dynamic activation (amber/orange or xenon-white – connect the colour you prefer) Range in E-approved mode: 359 m (1 lux) Range in Powerboost mode: 647 m (1 lux) Driving beam light pattern (enhances the vehicle’s original high beam) E-approved ECE R112 (Ref. 30), R7 (white position light) EMC-secured ECE R10 (does not interfere with radio) E-approved mode: 2,640 lumens (theoretical), 2,112 lumens (actual) Powerboost mode: 11,500 lumens (theoretical), 8,200 lumens (actual) Neutral-white light (5000K) ETM (Electronic Thermal Management) – adjusts the LED output depending on temperature for optimal lifespan Side-reflective optical system Pressure equalisation membrane Aluminium heat sink Adjustable stainless steel bracket Polycarbonate lens 36-month warranty Technical data: 150W (10 x 15W Cree LED) IP69K (water/dustproof) Cable with 4-pin DT connector Voltage 9–36 V Power consumption in E-approved mode: 2.2A @ 12V and 1.1A @ 24V (high beam only, without position light) Power consumption high beam Powerboost mode: 10.6A @ 12V and 4.8A @ 24V (high beam only, without position light) Dimensions & weight: Width: 247 mm Height: 145 mm (incl. bracket) Depth: 86 mm Weight: 1.6 kg Included: One Ledson Epix10+ white LED driving light 10" Bracket, bolts and screws for mounting the driving light with one or two mounting points DT connector (4-pin) – complement with Ledson Connect Installation instructions (see PDF here) Wiring instructions for cables (full installation manual included): Red: Driving light (+) Black: Driving light / Position light (– ground) White: Position light (+) white light Yellow: Position light (+) amber/orange light NOTE: The DT connector must not be cut, as this increases the risk of moisture damage and voids the warranty.