Epix10+ Auxiliary Light

Proprietary Swedish design Epix10+ from Ledson is an innovative series of auxiliary lights that elevates your vehicle to the next level. With a Swedish design language (developed in-house by Ledson) and outstanding performance, these auxiliary lights give your vehicle a truly unique and exclusive appearance that is guaranteed to draw attention. Experience exceptional brightness and design in perfect harmony. Dynamic position light Epix10+ activates the position light dynamically with a striking motion that guides the light smoothly from one side of the lamp to the other before it fully illuminates. This effect gives both you and your vehicle a distinct and unique character. Pulse-controlled Powerboost – It doesn’t get any easier Epix10 comes equipped with Ledson Powerboost – an extra power mode for those moments when you need (or simply want) maximum brightness. A simple action with the high beam lever activates this impressive intensity, allowing you to easily adjust the light output to your needs. With the new Powerboost generation from Ledson, you switch mode very easily using the flash-to-pass function (tapping the high-beam lever) through a few simple steps shown here. NOTE: your auxiliary light is delivered in E-approved mode; follow the instructions to activate Powerboost mode. Features and technical data: Selectable position light with dynamic activation (amber or xenon white – connect the colour you prefer) Range in E-approved mode: 359 m (1 lux) Range in Powerboost mode: 647 m (1 lux) Driving beam light pattern (enhances the vehicle’s standard high-beam pattern) E-marked ECE R112 (Ref. 30), R7 (white position light) EMC-protected ECE R10 (will not interfere with radio) E-approved mode: 2,640 lumens (theoretical), 2,112 lumens (actual) Powerboost mode: 11,500 lumens (theoretical), 8,200 lumens (actual) Neutral white light (5000K) ETM (Electronic Thermal Management) – adjusts LED output according to temperature for optimal lifespan Side-reflective optical system Pressure equalisation membrane Aluminium heat sink Adjustable stainless-steel bracket Polycarbonate lens 36-month warranty Technical data: 150W (10 x 15W Cree LED) IP69K (water/dustproof) Cable with 4-pin DT connector Voltage 9–36 V Power draw E-approved mode: 2.2A @ 12V and 1.1A @ 24V (high beam only, without position light) Power draw Powerboost mode: 10.6A @ 12V and 4.8A @ 24V (high beam only, without position light) Dimensions & weight: Width: 247 mm Height: 145 mm (incl. bracket) Depth: 86 mm Weight: 1.6 kg Included: One Ledson Epix10+ LED auxiliary light 10" Bracket, bolts and screws for mounting with one or two mounting points DT connector (4-pin) — complete with Ledson Connect Installation instructions (see PDF here) Wiring instructions (full documentation included): Red: High beam (+) Black: High beam / Position light (– ground) White: Position light (+) white light Yellow: Position light (+) amber light NOTE: The DT connector must not be cut, as this increases the risk of moisture damage and voids the warranty. Technical information: Mounting position/direction Vertical E-marking ECE R10, ECE R112, R7 Height (mm) 145 Width (mm) 247 Light source LED Powerboost Yes Number of LEDs 10 Lumens (theoretical) Powerboost: 11500 Lumens (actual) Powerboost: 8200 Manufacturer Ledson Light colour (secondary functions) Amber, White Size (inch) 10 inch Colour temperature 5000 IP rating IP69K 1 lux at distance 359, Powerboost: 647 Power consumption 12V 2.2A / 10.6A Power consumption 24V 1.1A / 4.8A Width (mm) 247 Depth 86 Beam pattern Driving beam Function (position) Driving light, Position light